AMCC 3ware 9650SE-2LP Uživatelská příručka stáhnout pdf (Strana 190)

Maintaining Units

178 3ware SAS/SATA RAID Software User Guide, Version 9.5.1

Selecting Self-tests to be Performed

For 3ware RAID controllers older than the 9690SA, two self-tests can be set:

one to check whether UDMA Mode can be upgraded (PATA drives only), and

another to check whether SMART thresholds have been exceeded. For the

9690SA, you can only check the SMART thresholds for drives. (For more

information about these self-tests, see the 3DM Reference section,

“Scheduling page” on page 228.)

Initially, these tests are set to run every 24 hours. You can change the schedule

for when they are run, and you can disable the tests, if you prefer not have to

have them performed.

To select self-tests to be performed

1 Choose

Management > Schedule from the menu bar.

The Scheduling page appears, showing the schedule for Rebuild Tasks.

2 Select Self-test Tasks from the drop-down list at the top of the page.

3 Check the boxes next to the self-tests you want to be performed.

To disable self-tests

Unlike scheduling of rebuilds and verifies, scheduling of self-tests is always

enabled.

To disable self-tests you must either remove all schedule times, or uncheck

the tests listed in the

Tasks column.

Note: These tasks will only be run during scheduled times if they are checked in

the Schedule Self-tests

section of the Scheduling page. If neither of the tasks is

checked, self-tests will never run, even if you have scheduled time slots set.

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 360 361

Žádné komentáře

AMCC 3ware 9650SE-2LP Uživatelská příručka Strana 190