AMCC 9000 Uživatelský manuál stáhnout pdf (Strana 32)

Installing the Hardware

24 3ware 9000 Series Serial ATA RAID Controller Installation Guide

To move units under Linux or FreeBSD

1 Upgrade your driver to the 9000 series driver. (For details, refer

to the Linux or FreeBSD Driver Installation section.)

2 Run the conversion utility to convert the units.

3 Power down the system, disconnect the drives from the 8000

controller and remove the controller from the system.

4 Install the 9000 controller and attach the drives to the 9000

board, as described earlier in this section.

To move units under Windows

1 Install the 9000 controller in your system, while leaving the

8000 controller installed.

2 Install the Windows driver. (For details, see “Driver Installation

Under Windows” on page 53.)

3 Run the conversion utility to convert the units.

4 Power down the system, disconnect the drives from the 7/8000

controller and remove that controller from the system.

5 Attach the drives to the 9000 board.

Moving Legacy JBOD Units to a 9000 Controller

To move legacy JBOD units under Linux or FreeBSD

1 Upgrade your driver to the 9000 series driver.

2 Power down the system, disconnect the drives from the 8000

controller and remove the controller from the system.

3 Install the 9000 controller and attach the drives to the 9000

board, as described earlier in this section.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 125 126

Žádné komentáře

AMCC 9000 Uživatelský manuál Strana 32