AMCC 3WARE 9500S Uživatelská příručka stáhnout pdf (Strana 194)

Chapter 10. Maintaining Your Controller

184 3ware Serial ATA RAID Controller User Guide

automatically charged again after the test completes. The whole process

usually takes between 8 and 12 hours.

While running the battery test and until charging is completed, write cache is

temporarily disabled.

For how to replace the battery, see the installation guide that came with your

controller.

To test the battery in a BBU in 3DM 2

1 On the menu bar, choose Monitor > Battery Backup.

2 On the Battery Backup page, click the Test Battery Capacity link.

Figure 85. Battery Backup Information Screen in 3DM

3 When a message cautions you that testing the battery will disable the

BBU for up to 24 hours, click OK to continue.

After the battery test starts, you will see the voltage start dropping;

eventually the battery voltage will say "LOW". This is part of the battery

test. After the voltage drops to a point, it will start charging again, and the

status will change to “Charging.” Eventually, the battery voltage will say

“OK” again.

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 301 302

Žádné komentáře

AMCC 3WARE 9500S Uživatelská příručka Strana 194